All programmes

Plumbing and Gas Technology

Study level TVET
Field Civil Engineering
Qualification levels
NP I · NP II · NC I · NC II National TVET Qualifications Framework

What this programme is about

Turn on a tap or flush a drain and the system should simply work. Making that happen reliably takes careful installation, measurement and testing.

You may learn pipe fitting, fixtures, drainage layouts, pressure testing and the safe handling of tools and materials. Gas work adds another level of responsibility because leaks, ventilation and combustion risks require careful procedures.

Drawings and measurements matter more than they may seem. A small alignment or sizing mistake can create a costly problem later in the installation.

Safe testing and correct installation practice are therefore central throughout the training.

When comparing providers, check workshop facilities, practical hours and whether the qualification connects to recognised trade or licensing pathways in your country.

Inside the curriculum

Pipe Fitting Water Supply Systems Drainage Systems Gas Installation Basics Plumbing Fixtures Pressure Testing Technical Drawing Trade Mathematics Workplace Safety

Skills you'll build

Pipe Installation Leak Testing Fixture Installation Drawing Interpretation Measurement Tool Handling Fault Diagnosis Drainage Installation

Where this can take you

Plumber
Plumbing Technician
Gas Installation Assistant
Maintenance Technician
Building Services Technician
Pipe Fitter
Facilities Maintenance Assistant
Plumbing Contractor
Site Services Assistant

What studying this programme is like

Water-supply topics can cover pipe sizing, fittings, valves and the basic layout of domestic or commercial systems.

Drainage training focuses on flow, traps, waste systems and the importance of correct gradients.

Gas modules may introduce pipework, appliances, ventilation and leak-testing principles where local regulations permit.

Students practise using hand and power tools safely while working to measurements and drawings.

Fault diagnosis becomes important once systems are in use, especially when the cause of a leak or pressure problem is not immediately visible.

Local codes matter because plumbing and gas work is regulated differently across jurisdictions.

Is this likely to suit you?

Good fit if you...

  • You enjoy practical trade work.
  • You are careful with measurements and safety.
  • You want a construction-related technical skill.
  • You are comfortable working with tools.
  • You may want self-employment or maintenance work.

Think twice if you...

  • You want a mainly classroom-based course.
  • You are careless with safety procedures.
  • You dislike physical installation work.
  • You have not checked local gas-work licensing rules.

Entry requirements

Entry requirements vary by technical institution and qualification level. Basic mathematics and practical aptitude are useful. Some programmes may require a previous school qualification or introductory trade training. Gas-related work may have separate licensing or competency requirements. Always check the provider's current admission requirements and local regulatory rules.

Common questions

Is the programme mostly practical?
Yes. Workshop and installation practice are usually central.
Will I learn gas installation?
Many programmes include gas-system basics, subject to local regulations and programme scope.
Is mathematics important?
Basic mathematics is used for measurement, pipe sizing and quantities.
Can I work independently after training?
That depends on local certification, licensing and experience requirements.
Does the course include maintenance?
Yes. Troubleshooting and maintenance are common components.
Still comparing?

Compare related programmes before you decide.

Compare qualifications, subject areas and the institutions offering each programme.

Explore similar programmes

Programme structures, duration and admission requirements can vary by institution and country. Always confirm current details with the institution before applying.